Posted on 5 Comments

Wheelchair Motors Part 2: Service

Cleaning, Replacement Parts & Reassembly

Housing Cleaned
Housing Cleaned

The housing of the contaminated motor was left to soak in diesel for a few hours to loosen the grok, this has come very clean. I couldn’t have used a stronger solvent here – the magnets are glued in place in the steel housing, I certainly didn’t want them coming loose!

Brushboxes
Brushboxes

Next into the diesel bath are the motor end bells with the brushgear. Attack with a stiff brush cleaned these up very well, some cotton buds served to clean out the brass brush holders.

Armatures After Skimming
Armatures After Skimming

Here are both armatures, having had their commutators resurfaced. I’ve completely removed all traces of the wear caused by the contamination, luckly the commutator bars are very heavy on these motors so can take quite a bit of wear before there’s not enough left to skim. I’ve not yet pulled off the old bearings, but they are all going to be replaced with new SKF bearings, as they’ve been contaminated with grok over the years of use. I’m also going to uprate the front motor bearings to rubber sealed instead of metal shielded, to help keep lubricant out of the motors if the gearbox seals ever fail again.

Gearbox
Gearbox

The gearboxes have been cleaned out with some elbow grease, assisted by a long soak in petrol, I’ve refilled them here with engine oil as temporary lube & to flush out the last remains of the old grease & solvent. The worm wheel in these boxes is bronze – so a GL4 gear oil will be required. (Some Extreme Pressure additive packs contain sulphur, and will readily attack copper alloys, such as brass & bronze).

Commutator End Bearings
Commutator End Bearings

Here’s the armatures, after the new SKF sealed bearings have been fitted to the commutator end, above, and the drive end, below. These will cause some extra drag on the armatures, and slightly higher power consumption as a result, but keeping the crap out of the motors is slightly more important.

Drive End Bearings
Drive End Bearings
Fresh Commutator Skim
Fresh Commutator Skim

The commutators have been lightly skimmed with abrasive cloth, and finished with 1500 grit emery. The armature on the right has been run for a short time to see how the new brushes are bedding in.

Old Seal Removed
Old Seal Removed

Finally, the old oil seals are pulled from the gearboxes. The worm gear bearing on the inside is actually a sealed version, with the external oil seal providing some extra sealing. I haven’t changed the gearbox bearings, as they seem to be in good order, this might get done at some point in the future.

New Oil Seals
New Oil Seals

The new seals ready to be driven into the bores.

5 thoughts on “Wheelchair Motors Part 2: Service

  1. Hi.

    Do you know how removed the bearings of gearbox?

    Thanks!!

    1. Hi Brokel,

      I would have thought a puller would work fine for pulling bearings if they’re stuck!

  2. Hello,
    Do you have any photos of the gearbox fully disassembled? I’m curious how the shaft stays in place. It appears that the output gear is free to slide along the splines and it’s held in position by the spring. What keeps the shaft in the gearbox? Thanks.

    1. Hi Blair,

      If I recall correctly, the mainshaft that the wheel attaches to is held in place with circlips behind the bearings 🙂

      Cheers

  3. I have a Quicky power chair I’m repairing for a charity. (was donated as not running),
    when I took the gear box apart, I noticed the slide out (output) pinion gear was missing. Where can I get a replacement?

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.